Final update (hopefully): It seems that I have been able to fix the issue. I’m not sure what exactly caused the problem but either removing fluidsynth or installing the wireplumber ppa fixed the issue and I have working audio again. I’ve also removed pulseaudio and undid my edit to the modprobe blacklist, as they were only done as a temporary solution and they are no longer necessary.

For the past three days, I’ve been having this issue where my computer starts with no audio and the only sound device listed is a “dummy output” device. I’ve tried looking online for solution but the only solution I found has to be redone manually every time I start/restart my computer. It also seems like this issue is common with and possibly specific to the sound card my computer has, which is an “Intel Sunrise Point-LP HD Audio”.

The solution that worked for me was to add blacklist snd_soc_avs to the modprobe blacklist and then run the two commands sudo alsa force-reload and pulseaudio. Adding snd_soc_avs to the blacklist permanently brought back my actually audio devices but it didn’t fix the audio nor did it remove the dummy output device. The two commands I listed do restore the audio and remove the dummy output device but they only work for the current session and I have to run them again after starting/restarting my computer.

I have no problem doing this if there isn’t a permanent solution but I would like a permanent solution, if possible.

  • gnuhaut@lemmy.ml
    2·
    6 days ago

    If we assume, for a moment, that your issue was in fact related to fluidsynth, which I kinda still think it might be, because of what fuser and the logs showed, it would be a good idea to undo your module blacklist thingy and reboot.

    If your slow boot issue persists, and you try to fix that tomorrow, then try looking at the bootup messages as described here:

    https://askubuntu.com/questions/25022/how-to-enable-boot-messages-to-be-printed-on-screen-during-boot-up

    If you reinstall pulseaudio to get back to where you were before, uninstall pipewire, those two shouldn’t be running simultaneously.

    Good luck and keep me updated if you manage to fix it somehow.

    • vortexal@lemmy.mlOP
      2·
      6 days ago

      Ok, even though I said I’d wait until tomorrow, I decided to try it again. It seemed to boot more or less normally but I did try someone else’s suggestion and it got audio working again. I did undo the edit I made to the modprobe blacklist and I did keep fluidsynth and pulseaudio uninstalled but I tried using the wireplumber ppa, like someone else suggested and my audio is working again. Granded, I have no idea what actually fixed the issue, so I don’t know who to fully credit but thanks for helping.